55. HSK taper on CNCs – what is it ?

CNC: HSK holder taper – what is it, and how is it different ?

The HSK taper is relatively new compared to BT, CAT and ISO.

The taper on HSK is hollow and short, with a taper of 1/10 or 5.72 degrees (as against 7/24 or 16.26 degrees on BT, CAT and ISO – see this earlier post).

The short taper enables a faster tool change and keeps the bearing of the machine spindle compact, close to where the machining is actually being done. The taper holding area of the machine spindle expands at higher speeds due to centrifugal force, causing a ‘bell-mouth’ effect in older systems. The HSK’s hollow taper expands with the machine spindle, reducing the bell-mouth effect.

The face on the holder butts against the spindle face, ensuring that the tool holder cannot be sucked up into the spindle farther when run at high speeds. Z dimensions on the part are hence accurately controlled.

HSK holders come in several sizes, HSK32 to HSK100. The number is actually the largest dimension on the holder.

Text and pics. source: CADEM NCyclopedia multimedia CNC training software.

Etc.

Gargoyles – beautiful drain pipes

The problem: When it rains, how do you divert water that falls on the roof away from the side of a building, to prevent it from running down masonry walls or stone walls and eroding them ? Solution: The Gargoyle

A Gargoyle is a fanciful creature with a spout that carries water in a roof gutter away from the wall. Architects in Europe a few hundred years ago came up with the idea of combining form and function for drain pipes. The water typically exited from the mouth of the gargoyle, although some architects made it exit from other orifices too (like the human figure in one of these pictures). I wonder why they had to be grotesque creatures instead of normal looking ones? Maybe the original inventor made a grotesque one and the later architects just followed suit?

The word gargoyle, derives from the French word ‘gargouille’, or throat (strange that the words for throat in some Indian languages sound similar -‘gala’ in Hindi, ‘gantla/gantlu’ in Telugu and Kannada).

This little piece of gyan comes from some scratching around that I did on the web for gargoyles. I mistook a bunch of lions (pics of them in this earlier post) on the wall of a Mumbai building for gargoyles, then found to my delight that gargoyles were something far more interesting.

Leave a Reply