Floating tap holder in CNC machining

CNC – Why do we use a floating tap holder?

What is a floating tap holder ? What is a floating tap holder ? Where is it used in CNC machining ? What problems does it solve, and how does it improve tapping ? An explanation.

When we cut a thread by any method, the following rule must be maintained:

Feed rate = Pitch x Spindle speed.

Floating tap holder in CNC machining

When we write a CNC program for tapping, we program a feed rate and spindle speed conforming to the above equation. The problem is that this rule is violated a few times during actual cutting:

1. Near the bottom of the thread the Z-axis is decelerating so it can stop at the exact destination, while the spindle is still rotating at the programmed speed.

2. When the tap reaches the bottom, the Z-axis has stopped and the spindle has been commanded to stop but is still rotating because of inertia.

3. The tap now reverses direction and takes time to accelerate to the commanded RPM. The Z-axis starts and takes time to accelerate to the commanded feed rate.

Basically in all these 3 cases, the Z-axis and the spindle are both doing their own thing independent of each other, saying “to hell with the thread rule”.

If the tap RPM and the feedrate do not follow the thread rule, you get damaged threads. If the tap is rotating but not moving forward, what you get is a bore (and a broken tap?) instead of a tapped hole. Both these happen in the violations listed above.

manual tapping without floating tap holder

The solution is to do the machine tapping like hand tapping. In hand tapping, you only rotate the tap and the hand gets pulled into the thread at a speed that is proportional to the pitch and the rotation speed of the hand. You allow the hand to get pulled in – allow it to float, in other words.

A floating tap holder does the same thing. The machine is controlling the Z-axis rigidly, but the tap holder has a float that allows the tap to be pulled in or out at a feed rate that is proportional to the spindle speed and pitch. It allows the tap to move axially independent of the machine’s axis.

Video courtesy: Taegutec India Pvt. Ltd.

Text source: CADEM NCyclopedia multimedia CNC training software.

Idea bulb

Transform production and profits dramatically, in just a few months.
With a CNC machine monitoring system.

Etc.

Fence needing protection ?

Barbed wire is meant to protect things, but this is the first time I’ve seen it being protected. I saw this sight in Aurangabad, out on a morning walk one day. The shop owner is too lazy to put it away in the shop every evening, so he just ties the roll of wire to a tree with a chain.

Barbed wire was originally invented to keep livestock (cattle, horses) within a boundary. Before it came along, the options were stone or wooden fences, or thorny bushes – too costly, or in the latter case, you also waited 1 year for your fence to grow after you planted it.

Barbed wire fencing was originally patented by a guy called Joseph Glidden in 1874, in the USA.

It’s amazing that the basic concept hasn’t changed at all in 140 years. I’m sure Glidden’s having a rough time in hell, after having been cursed by all the farm animals that have been born in the past 140 years !